Table of Contents
Advertisement
Screen Description
System up for
Displays the cumulative time since the power on of this Switching Hub.
Boot / Runtime
Displays this Switching Hub's firmware version.
Code Version
The left side displays the Boot Code, and the right side displays the Runtime
Code.
("Firmware Upgrade" described in Section 4.7.1 is about Runtime Code
upgrade.)
Hardware
Displays the hardware information.
Information
Version
CPU Utilization
DRAM / Flash
Size
DRAM User
Area Size
Administration
Items shown here are configured in accordance with Section 4.2.1 "System
Information
Administration Configuration".
Switch Name
System Address
Items shown here are configured in accordance with Section 4.2.2 "System IP
Information
Configuration".
MAC address
IP Address
Subnet Mask
Default
Gateway
Displays the hardware version information.
Displays the CPU utilization.
Displays the sizes of the installed DRAM and FLASH memories.
Displays the sizes of the user area memory and unused
memory.
Displays the Switching Hub name. The factory default setting
is blank. For configuration details, refer to Section 4.2.1.
Displays the MAC address of this Switching Hub. This value is
uniquely assigned to each device and cannot be changed.
Displays the Switching Hub's current IP address. "0.0.0.0" is
the factory default setting. For configuration details, refer to
Section 4.2.2.
Displays the Switching Hub's current subnet mask. "0.0.0.0" is
the factory default setting. For configuration details, refer to
Section 4.2.2.
Displays the IP address of the router for the default gateway.
"0.0.0.0" is the factory default setting. For configuration
details, refer to Section 4.2.2.
30
Advertisement
Table of Contents
