Led Display Switch Button Operation; Led Base Mode Configuration - Panasonic S24GPWR Operation Manual

1.6. LED Display Switch Button Operation

1.6.1. LED Base Mode Configuration

You can select either of the two LED display modes for this Switching Hub: "Status
mode" and "ECO mode."
The mode selected immediately after system boot is called "Base mode." By press-
ing and holding the LED display switch button for 3 seconds or more, you can
switch the Base mode. When the LED display button is pressed and held for 3 sec-
onds or more, all of the STATUS/ECO, PoE, GIGA, 100M and FULL LEDs are lit, and
the Base mode changes to the mode after switching.
● Status mode (factory default)
This mode displays each port status on the port LEDs according to the Port LED dis-
play mode. In the Status mode, the STATUS/ECO LED is lit green.
● ECO mode
All the port LEDs (Left) are turned off for power saving regardless of whether it is
connected or not to the terminal. In the ECO mode, the STATUS/ECO LED is
blinking green.
You can also configure the Base mode settings on the configuration screen of this
Switching Hub. For details, refer to Section 4.6.7.d of Operation Manual for Menu
Screens.
21