Panasonic S24GPWR Operation Manual page 46

Available commands are listed below.
C Configure the idle timeout settings for automatically terminating a console-connected session if
no input is made.
Press "C." The command prompt changes to "Enter console idle timeout>." Enter a value
from 0 to 60 (minutes). Entering "0" disables the automatic termination.
T Configure the idle timeout settings for automatically terminating a Telnet-connected session if
no input is made.
Press "T." The command prompt changes to "Enter telnet idle timeout>." Enter a value from
1 to 60 (minutes).
N Edit the login username.
1. Press "N." The command prompt changes to "Enter current password>." Enter the cur-
rent password.
2. After entering the correct password, the command prompt changes to "Enter new
name>." Enter a new username in 12 characters.
P Edit the login password.
1. Press "P." The command prompt changes to "Enter old password>." Enter the current
password.
2. If the password is correct, the command prompt changes to "Enter new password>."
Enter a new password in 12 characters.
3. After entering the password, the command prompt changes to "Retype new password>"
for confirmation. Enter the new password again.
L Configure the Telnet access settings.
Press "L." The command prompt changes to "Enable or Disable telnet server(E/D)>." Enter "E"
to enable the access. Enter "D" to disable it.
W Configure the Web browser access settings.
Press "W." The command prompt changes to "Enable or Disable web server (E/D)>." Enter
"E" to enable the access. Enter "D" to disable it.
A Configure a terminal accessible via Telnet.
Press "A" to move to the Telnet Access Limitation Menu. For configuration details, refer to
the next section (4.3.5.a).
I Configure the access settings for the IP address configuration software, bundled with the Pana-
sonic network cameras.
Press "I." The command prompt changes to "Enable or Disable IP setup interface (E/D)>."
Enter "E" to enable the access. Enter "D" to disable it.
B Configure the LED base mode settings.
Press "B" to move to the LED Basic Mode Configuration page. For configuration details, refer
to the next section (4.3.5.b).
Q Return to the parent menu.
46