Chapter 3 Installation; Delivery Check; Unpacking - Abbott PLEX-ID SP User Manual

Delivery check

Unpacking

Abbott Laboratories
Chapter 3
Installation
This section covers the relevant procedures to be carried out on receipt
of the instrument.
Move the packed instrument to its site of operation. To prevent
condensation, the instrument should be left in its protective, antistatic
plastic wrapping until the ambient temperature has been reached.
Unpack the instrument and accessories carefully with the arrows on the
transport package pointing upwards. Remove the instrument from the
package and place it on a level surface. Refer to the enclosed unpacking
instructions.
The following notes and instructions are sent with the instrument and
are immediately available when you open the package:
Packing instructions/Packing list
●
PLEX-ID SP User Manual
●
Caution Do not touch or loosen any screws or parts other than those
specifically designated in the instructions. Doing so might cause
misalignment and will void the instrument warranty.
Warning The PLEX-ID SP weighs approximately 28 kg [62 lbs.]
without the transport package and should be lifted with care. It is
recommended that two persons lift the instrument together, taking the
proper precautions to avoid injury.
To lift the instrument, put your fingers under the bottom on either
sides and lift it with your back straight.
Retain the original packaging and packing material for future
transportation. The packaging is designed to assure safe transport and
minimize transit damage. Use of alternative packaging materials may
invalidate the warranty. Also retain all instrument-related
documentation provided by the manufacturer for future use.
▲
▲
PLEX-ID SP User Manual 10/2009 N09455 23