Figure 3-11. Tip Comb Holder Transport Lock Removed; Figure 3-12. Removing The Transport Lock Of The Heating Block (A); Figure 3-13. Removing The Transport Lock Of The Heating Block (B) - Abbott PLEX-ID SP User Manual

Abbott Laboratories
Two eccentric pins
Figure 3–11. Tip comb holder transport lock removed
3. The transport lock of the heating block is removed according to
Figure 3–12. Unscrew the transport lock screw counterclockwise
(Figure 3–12). Lift the screw with the label attached (Figure 3–13).
Figure 3–12. Removing the transport lock of the heating block (A)
4. Remove the transport lock screw from the label (Figure 3–13).
Figure 3–13. Removing the transport lock of the heating block (B)
5. Then fasten the screw clockwise to its storage site on the heating
block base. The two screws on the heating block base guide the
heating block into the correct position.
Installation setups
PLEX-ID SP User Manual 10/2009 N09455
Installation
27