Changing The Heating Block; Figure 4-44. Inserting The Heating Block; Table 4-4. Processing Volumes Vs. Plate Types And Magnet Heads - Abbott PLEX-ID SP User Manual

Routine Operation

Changing the heating block

Changing the
heating block
58 PLEX-ID SP User Manual 10/2009 N09455
Table 4–4. Processing volumes vs. plate types and magnet heads
Head / Plate 24 Deep Well plate
Head for the 24
Deep Well plate
Head for the 96
Deep Well plate
Changing the heating block is controlled by the software. To change
the heating block, choose the Change_heatblock protocol by using the
Up and Down arrow keys. Then press
you to remove the magnets and in the end to insert them. The heating
block will thus rise. Remove the heating block and then replace it
(Figure 4–44 and Figure 4–45). Insert the heating block by first setting
it and then pressing it hard into place. The heating block will snap at
both ends if you have done it correctly. Press the
the task has been completed.
Figure 4–44. Inserting the heating block
96 Deep Well plate
200 – 5000 µl
– 50 – 1000 µl
START
96 Well plate
– –
20 – 150 µl
. The protocol requests
button when
START
Abbott Laboratories