Chapter 8 Troubleshooting Guide; Error Messages And Warnings; Table 8-8. Error Messages Reported - Abbott PLEX-ID SP User Manual

Error messages
and warnings
Code Error message
0 No error
1 The command was not recognized as
a valid command
2 The tip comb holder lifting
mechanism is out of position
3 The turntable rotating mechanism is
out of position
4 The magnetic head holder lifting
mechanism is out of position
5 The heating block lifting mechanism
is out of position
6 The shield plate turning mechanism is
out of position
7 Serial number already set
8 Invalid command parameter
9 Permanent parameters lost
10 Protocol name already used in other
directory
11 Internal software error
12 The requested movement is not
Continued
Abbott Laboratories
Chapter 8
Troubleshooting Guide
Note Do not use the instrument if it appears that it does not function
properly. ▲
Note that the instrument does not verify the logic flow of the received
commands.
When an error is detected, the current operation is terminated. After an
error, it is best to abort the current run and restart from the beginning
after the problem is fixed. The internal software has the following error
messages and warnings (Table 8–8).
Table 8–8. Error messages reported
Description
–
The command was not recognized as a valid command.
The magnet head position is in error.
The turntable position is in error.
The magnetic tips lift position is in error.
The heater lift position is in error.
The shield plate position is in error.
Attempt to set the serial number when it is already set.
Invalid command argument.
Nonvolatile parameters lost.
Cannot record a protocol with the same name to another directory.
Internal software error. This error is actually never reported because
the firmware halts on detection of an internal error. However, this
error may show up in the error log.
Cannot perform the requested movement. For example, the head and
PLEX-ID SP User Manual 10/2009 N09455 77