Selecting Fader Modes - Yamaha WC42260 Owner's Manual

60
Chapter 3—Operating Basics
Stereo Out [SEL] Button
The Stereo Out [SEL] button is used exclusively to select the Stereo Out for editing with the
SELECTED CHANNEL controls. Its indicator lights up when the Stereo Out is selected.
Each time it's pressed, the selection toggles between the Stereo Out's left and right channels.
The SELECTED CHANNEL PAN/SURROUND [L] and [R] buttons can also be used to
select the left and right channels.
If the currently displayed page contains a Stereo Out parameter, that parameter is selected
automatically when the Stereo Out [SEL] button is pressed. If the currently selected page
contain no such parameter, the page that does contain such a parameter is selected auto-
matically. For example, if a Delay page for the Input Channels is currently selected when the
Stereo Out [SEL] button is pressed, the Delay page showing the Stereo Out Delay parameter
is selected automatically.
Auto Channel Select & Touch Sense Select
While the Auto Channel Select preference is on (see page 275), channels can be selected by
moving the corresponding fader or Encoder, or by turning on the corresponding [AUTO],
[SOLO], or [ON] button. Note that you can use the [AUTO] buttons to select channels only
during Automix recording or in Automix record ready mode.
While the Fader Touch Sense SELECT preference is on (see page 276), channels can be
selected simply by touching the fader knobs.

Selecting Fader Modes

The exact function of each fader depends on the selected Layer and Fader mode.
1 Select a Layer, as explained on page 58.
Use the FADER MODE buttons to select a Fader mode.
2
[FADER]: Channel faders control Input Channel levels or Output Chan-
nel master levels, depending on the selected Layer.
[AUX/MTRX]: Channel faders control Aux or Matrix Send levels,
depending on the selected Layer.
The indicator of the currently selected FADER MODE button lights up.
The following table shows the channel fader functions for each Layer and Fader mode.
Layer
1–24
25–48
49–72
73–96
Master
Remote
DM2000 Version 2—Owner's Manual
Fader
Mode
Fader
Aux/Mtrx
Fader
Aux/Mtrx
Fader
Aux/Mtrx
Fader
Aux/Mtrx
Bus Out 1–8:
Fader
master level
Bus Out 1–8:
Aux/Mtrx
Matrix Send level
Fader
1–4
Aux/Mtrx
1–8 9–16
CH 1–24: level
CH 1–24: Aux Send level
CH 25–48: level
CH 25–48: Aux Send level
CH 49–72: level
CH 49–72: Aux Send level
CH 73–96 level
CH 73–96: Aux Send level
Aux Send 1–12: master level
Aux Send 1–12: Matrix Send level
Operation depends on the selected target.
See "About Remote Layers" on page 253 for more information.
FADER
Fader
17–20 21–24
Matrix Send 1–4:
master level
No operation: Fad-
ers fixed at –∞
FADER MODE
AUX / MTRX