Studio Monitoring - Yamaha WC42260 Owner's Manual

Control Room Setup
Control room monitoring is configured on the Control Room Setup page.
Use the MONITOR [DISPLAY] button to locate the Control Room Setup page.
1
2 Use the cursor buttons to select the ASSIGN buttons in the left-hand box,
and use the Parameter wheel to select an Output Channel in the right-hand
box.
Bus Outs, Aux Sends, or Matrix Sends can be assigned to the [ASSIGN 1] and [ASSIGN 2]
buttons.
Press [ENTER] to assign the selected Output Channel.
3
Once assigned, the selected Output Channel appears highlighted in the right-hand box.
The other parameters on this page are as follows.
CONTROL ROOM DIMMER LEVEL: This determines the amount of attenuation
applied to the Control Room Monitor and Surround Monitor signals by the Dimmer func-
tion. Use the cursor buttons to select it, and use the Parameter wheel or INC/DEC buttons
to set it from.
MONO: This button, which works in unison with the CONTROL ROOM [MONO] but-
ton, can be used to switch the Control Room Monitor signal into mono.

Studio Monitoring

The DM2000 features dedicated outputs, source selection, and level control.
STUDIO
CONTROL STEREO
ROOM
11 12
AUX AUX
0 10
STUDIO
LEVEL
The Studio Monitor signal is output by the STUDIO MONITOR OUT
+4 dB (BAL) 1/4-inch TRS phone jacks.
The Studio Monitor signal source is selected by using the STUDIO buttons.
[CONTROL ROOM]: Selects the Control Room Monitor.
[STEREO]: Selects the Stereo Out.
[AUX 11]: Selects Aux Send #11.
[AUX 12]: Selects Aux Send #12.
The level of the Studio Monitor signal can be set by using the STUDIO
LEVEL control.
159
Studio Monitoring
DM2000 Version 2—Owner's Manual