Yamaha WC42260 Owner's Manual page 226

226
Chapter 19—Pro Tools Remote Layer
Encoders & Push-Switches
The Encoders are used to set pan and send levels and select I/O assignments. The Encoder
push-switches are used to mute sends, reset send levels and panpots, and confirm I/O
assignments. Their exact operation depends on the currently selected Encoder mode, as
shown in the following table.
Encoder Mode
[PAN]
[SEND LEVEL]
[INPUT]
[OUTPUT]
[SEND ASSIGN]
[AUTO] buttons
These buttons are used in conjunction with the AUTOMIX section to set the Automation
mode of each channel. See "Setting the Automation Mode" on page 250 for more informa-
tion.
[SEL] buttons
These buttons are used to select channels (see page 239), to select inserts (see page 245), and
to bypass inserts (see page 246).
[SOLO] buttons
These buttons are used to solo channels. See "Soloing Channels" on page 241 for more
information.
[ON] buttons
These buttons are used to mute channels. See "Muting Channels" on page 241 for more
information.
Faders
The faders are used to set channel levels (see page 240), or to set send levels in
Flip mode (see page 243).
DM2000 Version 2—Owner's Manual
Encoder
Pan (see page 241)
Send levels (see page 243)
Select input source (see page 239)
Select output destination (see page 240)
Select send destination (see page 242)
Push-switches
Reset pan (see page 247)
Mute sends (see page 243)
Send pre/post (see page 242)
Reset send levels (see page 247)
Confirm selection
5
0
5
10
15
20
30
40
50
10 0
5
10
15
20
30
40
50
60
70