Table of Contents
Advertisement
86
Chapter 7—Input Channels
Gate Edit Page
Gate settings can be viewed and set on the Gate Edit page. If the Auto DYNAMICS Display
preference is on, this page appears automatically when a gate control in the SELECTED
CHANNEL DYNAMICS section is operated.
Use the LAYER buttons to select Input Channel Layers, and use the [SEL] but-
1
tons to select Input Channels.
Use the SELECTED CHANNEL DYNAMICS [DISPLAY] button to locate the
2
Gate Library page, and then recall a Gate preset that contains the gate type
that you want.
See "Gate Library" on page 170 for more information.
Use the SELECTED CHANNEL DYNAMICS [DISPLAY] button to locate the
3
Gate Edit page.
Use the cursor buttons to select the parameters, and use the Parameter
4
wheel, INC/DEC buttons, and [ENTER] button to set them.
KEYIN SOURCE: This determines the trigger source for the currently selected Input
Channel's Gate. Trigger sources include SELF (the Gate's own input signal), CHANNEL
(another Input Channel), or AUX (an Aux Send from 1–12). Input Channel trigger sources
are selectable in blocks of 12 channels. For example, if Input Channel #1 is currently
selected, an Input Channel from 1–12 can be selected as the trigger source. However, if
Input Channel #13 is currently selected, an Input Channel from 13–24 can be selected.
STEREO LINK: This allows you to pair Gates for stereo operation even when Input Chan-
nels are not paired. Input Channel Gates are paired either horizontally or vertically depend-
ing on the Pair mode setting for the currently selected Input Channel. See "Pairing
Channels" on page 144 for more information on horizontal and vertical pairing. When
Input Channels are paired, this parameter is turned on automatically and cannot be
changed.
CURVE: This displays the gate curve (i.e., input level vs. output level).
TYPE: This is the gate type used by the currently selected Input Channel's Gate.
Meters: These meters indicate the levels of the currently selected Input Channel and its
horizontal or vertical partner. The GR meter indicates the amount of gain reduction being
applied by the currently selected Input Channel's Gate.
ON/OFF: This turns the currently selected Input Channel's Gate on and off. It works in
unison with the SELECTED CHANNEL DYNAMICS [GATE ON] button.
PARAMETER: These controls are used to set the Threshold, Range, Attack, Decay, and
Hold parameters.
DM2000 Version 2—Owner's Manual
Advertisement
Table of Contents
