Table of Contents
Advertisement
108
Chapter 9—Bus Outs
Muting Bus Outs (ON/OFF)
Bus Outs can be muted by using the channel strip [ON] buttons.
Press the LAYER [MASTER] button to select the Master Layer.
1
2
Use channel strip [ON] buttons 1–8 to mute the Bus Outs.
ON
Grouping Master Mutes (ON/OFF)
Bus Out Mutes can be grouped with the Mutes of other Output Channels. See "Grouping
Output Channel Mutes (ON/OFF)" on page 149 for more information.
Setting Bus Out Levels
Bus Out levels can be set as follows.
Press the LAYER [MASTER] button to select the Master Layer.
1
2
Press the FADER MODE [FADER] button to select Fader mode.
Use faders 1–8 to set the Bus Out levels.
3
Refer to the legend on the right side of the faders when setting Bus Out levels.
Grouping Master Faders
Bus Out faders can be grouped with the faders of other Output Channels. See "Grouping
Output Channel Faders" on page 146 for more information.
Sending Bus Outs to Matrix Sends
Bus Out signals can be sent to the Matrix Sends. See "Matrix Sends" on page 121 for more
information.
Delaying Bus Outs
Each Bus Out features a Delay function. See "Delaying Channel Signals" on page 141 for
more information.
Inserting GEQs
Internal GEQs can be inserted into the Bus Outs. See "About the GEQs" on page 183 for
more information.
Soloing Bus Outs
Bus Outs can be soloed. See page 142 for more information.
Pairing Bus Outs
Bus Outs can be paired for stereo operation. See "Pairing Channels" on page 144 for more
information.
DM2000 Version 2—Owner's Manual
The [ON] button indicators of Bus Outs that are on light up.
10
0
5
5
0
10
5
15
10
20
15
30
20
40
30
50
40
60
50
70
Advertisement
Table of Contents
