Trim Mode; Arming Parameters For Automation - Yamaha WC42260 Owner's Manual

Trim Mode

Trim mode can be set as follows.
1 While holding down a channel's [AUTO] button, press the AUTOMIX [REL-
ATIVE] (TRIM) button.
The channel's Automation mode is displayed on the corresponding channel strip display
while its [AUTO] button is pressed.
Pro Tools
Auto trim/write
Auto trim/touch
Auto trim/latch
Auto trim/read
Grouped channels are set together. You can temporarily disable a group in order to set indi-
vidual channels by pressing and holding the USER DEFINED KEYS [12] (CTRL/CLUTCH)
button.
The following shortcuts apply.
To do this...
Set Trim mode for all channels
Set Trim mode of all selected channels
In Trim mode, you can display channel and send level values relatively (instead of absolute
decibel values) on the channel strip displays by holding down the USER DEFINED KEYS
[13] (ALT/FINE) button while adjusting the faders and Encoders.

Arming Parameters for Automation

Parameters can be selected for automation recording as follows.
Use the following AUTOMIX-OVERWRITE buttons to arm parameters.
1
AUTOMIX-OVERWRITE Buttons
[FADER] (FADER)
[ON] (MUTE)
[PAN] (PAN)
[AUX] (SEND)
[AUX ON] (SEND MUTE)
[EQ] (PLUG-IN)
The button indicators for armed parameters light up.
The following shortcuts apply.
To do this...
Arm all parameters
Inverse armed parameter selection
Channel Strip Displays
TWrt
TTch
TLch
TRd
USER DEFINED KEYS [5] + AUTOMIX [RELATIVE]
USER DEFINED KEYS [5] + USER DEFINED KEYS [4] +
AUTOMIX [RELATIVE]
Pro Tools
Volume
Mute
Pan
Send level
Send mute
Plug-in
USER DEFINED KEYS [5] + AUTOMIX-OVERWRITE [FADER],
[ON], [PAN], [AUX], [AUX ON], or [EQ]
USER DEFINED KEYS [13] + AUTOMIX-OVERWRITE [FADER],
[ON], [PAN], [AUX], [AUX ON], or [EQ]
Automation
[AUTO] Button Indicators
Flashing red/orange (Record Ready)
Orange (Recording)
Flashing green/orange
Do this!
Do this!
DM2000 Version 2—Owner's Manual
251