Appendices; Appendix A. Manufacturer Declaration - Nuvo invu User Manual

10

Appendices

Appendix A. Manufacturer Declaration

This appendix describes the system's compliance with applicable IEC and RF standards.
Overview
See the following tables for specific information regarding the system's compliance with the IEC
60601-1-2 standards.
The INVU by Nuvo™ System is intended for use in the electromagnetic environment specified below.
The customer or the user of the INVU by Nuvo™ device should ensure that it is used in such an
environment.
Table 10-1. System Compliance Information – Electromagnetic Emissions
The INVU by Nuvo™ system is intended for use in the electromagnetic environment specified below.
The customer or the user of INVU by Nuvo™ system should assure that it is used in such an
environment.
Emissions test
Radiated emissions:
FCC 47 CFR;
IEC 60601-1-2;
AC power lines conducted
emissions:
FCC 47 CFR;
IEC 60601-1-2;
Harmonic emissions:
IEC 60601-1-2;
Voltage fluctuations flicker
emissions:
IEC 60601-1-2;
NV-UMLS-0001
Compliance
Class B
Class B
Complies
Complies
Invu by Nuvo™User Manual
Electromagnetic environment – guidance
The INVU by Nuvo™ system uses RF energy only
for its internal function. Therefore, its RF
emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
The INVU by Nuvo™ system is suitable for use in
all establishments other than domestic and those
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes.
Appendices
71