Initiating A Monitoring Session - Nuvo invu User Manual

Using the INVU Sensor Band™

Initiating a Monitoring Session

5.2 Initiating a Monitoring Session
Your medical care team will prescribe the monitoring session duration (up to 5 minutes) and
the number of sessions that should be conducted. Starting a session will only be possible
during the clinic availability hours and when your session appointment was scheduled.
Note:
A monitoring session will not be initiated unless you waited at least 10 minutes from
the end of your last monitoring session.
Turn the INVU Sensor Band™ ON by shortly pressing on the Controller ON/OFF power
button, located on the right side of the INVU Sensor Band™.
Once the INVU Sensor Band™ is powered ON, wait until a steady green light appears on
the Controller.
Verify your Bluetooth connectivity is enabled on your mobile device and that you have
access to the Internet. Internet access must be available either via Wi-Fi (recommended)
or a mobile phone data plan (i.e., the cellular network).
Note:
The INVU Sensor Band™ transfers data to the mobile application via
communication. You should be near your mobile device at a distance that does not exceed
5 meters (about 16 feet), and there should be no walls in between.
Launch the INVU™ App and log in.
Press START. The application will connect to the device if it wasn't previously connected.
A steady blue LED light on the controller indicates the band is connected.
Note:
After the band is powered ON, you have fifteen minutes to start a monitoring
session. If a monitoring session does not begin within fifteen minutes, the INVU Sensor
™
Band will turn itself Off automatically.
Monitoring sessions are best performed in a comfortable position while lying down on
the back or sitting or reclining in a quiet room. minimize your movements as much as
possible during monitoring.
Press START to begin the monitoring session.
The monitoring session begins with a signal quality check. Follow the session
preparation instructions to ensure proper use of the device.
Note:
A blue light on the band Controller blinks until the session ends. This indicates the
monitoring is working properly and that data is transferring via the Bluetooth connection
to your smartphone.
26
Figure 5-9. INVU Sensor Band™ power button
Bluetooth
Nuvo Group Ltd.