Nuvo invu User Manual page 30

Using the INVU Sensor Band™
Applying the INVU Sensor Band™
APPLYING GEL
Place the INVU Sensor Band™ on a flat surface (like a table), with the sensors facing
upwards (see Figure 5-7).
Apply the gel provided in the package to all 8 detachable sensors: three on the upper
strip of the band, three on the lower strip, and one on each side of the band.
Apply a substantial amount of gel. The amount of gel used should be about the size of a
peanut and should only fill up the center notch, as shown below in Figure 5-7.
Caution:
Do not apply the gel on any of the acoustic sensors.
Figure 5-7. Applying gel in the center notch of the detachable sensors
24 Nuvo Group Ltd.