Appendices; Appendix A. Manufacturer Declaration - Nuvo INVU User Manual

Appendices

System Specifications
10 Appendices

Appendix A. Manufacturer Declaration

This appendix describes the system's compliance with applicable IEC and RF standards.
Overview
See the following tables for specific information regarding the system's compliance with the IEC
60601-1-2:2014 standards.
The INVU by Nuvo™ System is intended for use in the electromagnetic environment specified below.
The customer or the user of the INVU by Nuvo™ device should ensure that it is used in such an
environment.
Table 10-1. System Compliance Information – Electromagnetic Emissions
The INVU by Nuvo™ system is intended for use in the electromagnetic environment specified below.
The customer or the user of INVU by Nuvo™ system should assure that it is used in such an
environment.
Emissions test
CISPR 11
FCC 47 CFR; CISPR 11
Harmonic emissions:
IEC 60601-1-2:2014;
Voltage fluctuations flicker
emissions:
IEC 60601-1-2:2014;
90
Compliance
Group 1
Class B
Complies
Complies
Electromagnetic environment – guidance
The INVU by Nuvo™ system uses RF energy only
for its internal function. Therefore, its RF
emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
The INVU by Nuvo™ system is suitable for use in
all establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Nuvo Group Ltd.