Charging The Invu Sensor Band™ Battery - Nuvo invu User Manual

The battery is integrated into the INVU Sensor Band™ Controller and is charged by the
medical-grade power supply through the USB type C connector. The medical-grade power
supply is supplied as part of the INVU Sensor Band™ package.
•
Charging time (from an empty battery to a fully charged battery) is around two hours.
•
Under typical conditions, a fully charged battery will provide ~4.5 hours of continuous
monitoring.
Note: The
INVU Sensor Band™ battery is pre-charged before shipping. However, it is
recommended recharging it before first use to a fully charged battery.
3.3 Charging the INVU Sensor Band™ Battery
Power OFF the INVU Sensor Band™.
Note:
INVU Sensor Band™ battery can be charged ONLY if the INVU Sensor Band™ power
is OFF. Attempting to charge the INVU Sensor Band™ when it is powered ON will
automatically power it OFF.
Remove the band from your body before charging. For additional information see
"Removing the INVU Sensor Band™ " in section 5.3.
Caution:
Do not use any other charging cable or a power supply other than the one
supplied in the INVU Sensor Band™ package!
Warning:
Remove the INVU Sensor Band™ from your body before connecting the cable
for charging! Do NOT charge the battery while the INVU Sensor Band™ is worn.
Insert the USB type-C plug of the supplied power supply to the Micro USB charging
socket at the side of the plastic controller.
If you connect the charging cable while the device is turned ON, the device will
automatically turn OFF upon charging.
The minimum charging capacity to start a monitoring session is approximately 20%,
which is equivalent to about 45 minutes of monitoring.
The band battery status (charging capacity) is displayed on the INVU™ App Home screen.
When charging is complete, disconnect the USB type-C plug from the Controller.
NV-UMLS-0001
Figure 3-5. Charging INVU Sensor Band™ battery
Invu by Nuvo™User Manual
Know Your INVU Sensor Band™
13