Table of Contents
Advertisement
Handlig of the ink cartridge
!! IMPORTANT !!
- Once a cartridge is inserted, never remove or re-insert the cartridge until it runs out. It may cause air to go
inside the ink cartridge, then air enters the ink line, resulting in the breakdown of the machine.
- Be sure to replace with an cartridge of identical type.
- Never allow the machine to stand with an ink cartridge removed. The print heads may become clogged.
- Never store the ink cartridges in the location exposed to open flame,or where high temperature may occur.
- Unlike the ECO-SOL (MAX) INK, the cartridges don't need to be shaken before inserting.
Checking for remaining Ink
!! IMPORTANT !!
The display shows an approximate guide to the amount of remaining ink, which may differ somewhat from
the actual amount remaining.
Optimizing printing to match media thickness
-Head height
-Bidirectional adjustment
-Feed calibration
When you enable the feed calibration in the RIP, the setting done on the machine will be ignored.
Preset function
You can group together the settings shown below and save them as a preset.
-PREHEATING
-BLOWER FAN
-SHEET TYPE
-SHEET WIDTH
-SHEET POS.
-HEAD HEIGHT
-ADJUST BI-DIR
-CALIBRATION
-FEED FOR DRY
-VACUUM POWER
-FULL WIDTH S
7-12
Advertisement
Table of Contents
