Table of Contents
Advertisement
Tighten up the 2 screws shown in the figure with pressing
6
Drive Shaft Support downward.
Move Head Carriage over a few times in a whole width and
check the position of the belt on Drive Pulley again.
There is another screw for fixing Drive Shaft
Support on the machine with the Servial Number
from ZU50190 to ZU50220. In this case, tighten
up this another screw after tightening up 2
screws shown in the figure until Screw hits
Motor Base
.
Scan Motor Base
To start the aging, select [MOTOR MENU] > [AGING] >
7
[SCAN] and press [ENTER] key.
Check the belt position while aging.
8
Check there is a gap at A and B shown in the figure.
Go to the procedure 5 again if there is no gap at A and B.
Scan
<Front View>
Screw
4-46
Drive Shaft Support
SERVICE MENU
MOTOR MENU
MOTOR MENU
AGING
AGING
SCAN
OK
A
B
Screw
[
]
[
]
[ENTER]
Advertisement
Table of Contents
