Table of Contents
Advertisement
When the injector becomes filled with the ink, select [I/S
8
MENU] > [I/S CONTROL] > [PRESS PUMP 1- 6] > [CLOSE]
and press [ENTER] key.
Remove the syringe from Ink Tube and drain the ink
9
drain bottle through the Funnel.
Repeat the step from 4 to 9 4 or 5 times to remove
10
the ink in Sub Tank. This is for supplying the ink with air
into Sub Tank because the air could go into Supply Pump.
When you pull the ink at 4 or 5 times,
pulled by a hexagon wrench or the like to prevent the
ink from going back.
Open I/C Slot Cover and remove Ink Cartridges.
11
Then, insert Dummy Cartridges straight for preventing the
leak of the ink.
Do not remove the Ink Cartridge
more than necessary. Do not
place the Ink Cartridge with the
hole faced up.
These cause air to go into the
cartridge.
to the
keep the piston
NG
5-19
SERVICE MENU
I/S MENU
Wrench
Dummy Cartridge
I/S MENU
I/S CONTROL
[
] [
]
I/S CONTROL
PRESS PUMP1
[
] [
]
PRESS PUMP1
CLOSE
[ENTER]
I/C Slot Cover
Advertisement
Table of Contents
