Table of Contents
Advertisement
Head moves to the position where the value is +2.00mm.
4
It is only possible to move Head stepwise downward.
When you move Head upward, press [
Head upper end once and then move downward.
Move Head downward to the position where the surface
5
of Head contacts the cap when being seen crossly, then
press [ENTER] to update the adjustment value.
-When you press [ ] key, Head moves downward in 0.25mm
unit.
-When you press [
where the value +2.00mm.
-When you press [
and the capping is carried out and then exiting the menu.
Heads are capped and you can go out from the menu without
updating the adjustment value.
If it is difficult to see whether Head makes
contact with the cap, irradiate Head and Cap
Top with a penlight.
In this case, move down Head while irradiating
the back plate of Head Carriage through the
gap between Head and the cap. When the
light on the back plate of Head Carriage
cannot be seen, this means that Head makes
contact with the cap.
] key to move
] key, Head moves to the highest position
] key, the adjustment value is not updated
4-30
Advertisement
Table of Contents
