Table of Contents
Advertisement
Turn off the Sub Power SW. Then, turn off the Dryer Main
11
Power SW and the Printer Main Power SW.
Remove the O Ring, the Tube Joint and the Adapter
12
Screw from the Ink Tube. (These will not be used again.)
Then, cover the tops of Ink Tubes with the tape to prevent
ink leaking.
You can cut the Ink Tube by scissors to trash
Adapter Screw, Tube Joint and O ring.
Ink Tube
Remove two Nylon Rivets fixing the Protective Plate.
13
Remove all Flexible Cables that come from the Cable
Veyor that is connected to the Carriage Board.
Remove the Guide Plate and Cable Guide from the Cable
14
Veyor.
<Rear view>
Dryer Main Power Switch Printer Main Power Switch
Nylon Rivet
Protective Plate
3-33
Ink Tube
Adapter Screw
Tube Joint
O Ring
Flexible Cable
Guide Plate
Cable Guide
<Front view>
Advertisement
Table of Contents
