Roland Advanced Jet AJ-1000 Service Notes page 150

SERVICE MENU
I/S MENU
PRINT MENU
LINEAR ENCODER
This menu is for checking Linear Encoder and recording the position of the sheet edge with
Clear Sheet (SHEET TYPE : CLEAR). Refer to [4-6 LINEAR ENCODER SETUP].
PRINT MENU
CALIB.DEFAULT
This menu is used for Calibration. Refer to [4-8 CALIBRATION].
*More than 510mm setup width is required when performing TEST PRINT.
PRINT MENU
TEST PATTERN
PRINT MENU
HEAD HEATER
HEAD HEATER is OFF
HEAD HEATER is ON
I/S MENU
I/S CHECK
This menu is for checking the motors and sensors of Head(Up/Down), Wipers and Slider.
**Make sure to cap the head before performing this check.
Error Display
I/S MENU
PUMP CHECK
This menu is for checking the motors and sensors of Pressure Pumps, Supply Pumps and Maintenance
Liquid Pump.
Error Display
NOW PROCESSING..
POS: 1361.00mm
LOWER PINCHROLL
PINCHROLL is UP
CALIB.DEFAULT
TEST PRINT
CALIB.DEFAULT
SETTING
TEST PATTERN
FILL
100% fill pattern of all heads will be printed.
Printing is done by 360 x 180dpi / 1 pass.
TEST PATTERN
BI-DIR.CHECK
It is for checking the shifting of Bidirection Printing.
This menu is used for checking HEAD HEATER.
HEAD1 _ 28 C
A temperature and condition(On/Off) by a thermister is displayed.
HEAD HEATER(On/Off) can be changed with ENTER key.
*Note that the heater keeps heating without controlling the
temperature if it is turned on in this menu. Never leave the heater
on for a long time.
The heater becomes off automatically, when you go out from
HEAD1 * 28 C
this menu.
Check the heater temperature increases when turning on the
switch and the heater temperature is close to the room
temperature when it turned off.
NOW PROCESSING..
HEAD UP/DOWN : HEAD UP/DOWN MOTOR or SENSOR has a problem.
WIPER : WIPER MOTOR or SENSOR has a problem.
SLIDER : SLIDER MOTOR or SENSOR has a problem.
NOW PROCESSING..
PRESS PUMP 1 to 6 : PRESSURE PUMP MOTOR or SENSOR has a problem.
SUPPLY PUMP : SUPPLY PUMP or SENSOR has a problem.
M-LIQUID PUMP : MAINTENANCE LIQUID PUMP MOTOR or SENSOR has a problem.
4-3
LINEAR ENCODER
SETUP COMPLETED
LINEAR ENCODER
SETUP FAILED
LINEAR ENCODER
HEADBOARD FAILED
PERFORMING
TEST PRINT
SETTING
+0.05% +0.10%
PERFORMING
TEST PRINT
PERFORMING
TEST PRINT
I/S CHECK
COMPLETED
normal
I/S CHECK ERROR
HEAD UP/DOWN
error
POSITION HEAD
error(HEAD POSITION)
PUMP CHECK
COMPLETED
normal
PUMPCHECK ERROR
PREESS PUMP1
error
normal (beeps 1 time)
error (beeps 2 times)