When a key is pressed, its key name will be shown. When two or more keys are pressed simultaneously, "KEY ERROR" will show up, which defines no key is pressed.

When the [

If this menu is left for 10 seconds with no key pressed, it returns out of this menu, then the names of keys that are not checked will show up with beep.

If no beep when back out this menu, it means all keys are correctly checked. While in this menu, [POWER] key does not work to turn OFF/ON.

SUB MENU

LCD/LED/BUZ CHK

This menu is to check LCD, LED and Buzzer. While in this menu, the function check of the LCD, LED and the Buzzer can be performed.

ON/OFF test for all LEDs, Contrast ON/OFF test for LCD, Back light test for LCD, Buzzer ON/OFF test, Display check for the Cursor key on LCD,

All characters display check on LCD can be performed.

NOW PROCESSING..

Filling finished (Beeps once)

NOW PROCESSING..

This menu should be run before you replace tube to set the machine prepared for it. Refer to [3-6, Ink Tube Replacement].

NOW PROCESSING..

This menu should be run when you replace tube to set the machine finalized after replacing tube. Refer to [3-6, Ink Tube Replacement].

: Small ink consumption, minimum cleaning just to keep nozzles in good condition

This menu is to check FANs. Select fan by [

When back out of this menu, fan will be OFF automatically.

DATE

05/09/10

TIME

01:01:59

When the battery is run out, "B" will be displayed.

TIME

01:01:59

This menu is for setting date and time display.

When battery runs out, system parameters will be flagged, then LCD shows [B] beside the time. In this case, the battery should be replaced with a new one.

However, even after you replaced a battery, this flag will not be removed automatically. By pressing [ENTER] key to set TIME, this flag will be cleared.

The TIME that you set up here will be diverted to calculate hours for maintenances and used to display time in log file.

Note that setting the TIME in this menu will affect to other maintenaces log.

The record of this TIME resetting will be saved in log file, which has previous date before resetting and the reset TIME as reference.

0110 0000

bit # [1 2 3 4

5 6 7 8]

This menu is to check DIP Switches. You can check real-time status from the left bit #1 to the right #8. 0 for OFF, 1 for ON.

] key is pressed then released, you can back out of this menu. To check all keys, the [

As per display

4-7

FILL M-LIQUID : Fill maintenance liquid

SUPPLY1 : Pump makes one revolution