Xerox Printer fwww User Manual page 29

Media type
• To avoid damaging the machine, use only
transparencies designed for use in laser
printers.
• Transparencies used in the machine must be
able to withstand 180° C (356° F), the machine's
fusing temperature.
• Place them on a flat surface after removing
them from the machine.
• Do not leave them in the paper tray for long
periods of time. Dust and dirt may accumulate
on them, resulting in spotty printing.
• To avoid smudging caused by fingerprints,
handle them carefully.
Transparencies
• To avoid fading, do not expose printed
transparencies to prolonged sunlight.
• Ensure that transparencies are not wrinkled,
curled, or have any torn edges.
Caution
• Recommended media: Transparency for
a Color Laser Printers produced by HP,
Xerox and 3M.
• It is not recommended to use
paperbacked transparencies such as
Xerox 3R91334 which can cause a jam
or be scratched.
Guidelines Media type
• To avoid damaging the machine, use only labels
designed for use in laser printers.
• When selecting labels, consider the following
factors:
- Adhesives: The adhesive material should be
- Arrangement: Only use labels with no
- Curl: Prior to printing, labels must lie flat with
Labels
- Condition: Do not use labels with wrinkles,
• Make sure that there is no exposed adhesive
material between labels. Exposed areas can
cause labels to peel off during printing, which
can cause paper jams. Exposed adhesive can
also cause damage to machine components.
• Do not run a sheet of labels through the
machine more than once. The adhesive backing
is designed for only a single pass through the
machine.
• Do not use labels that are separating from the
backing sheet or are wrinkled, bubbled, or
otherwise damaged.
• Do not print on media smaller than 76 mm
Card stock or (3 inches) wide or 127 mm (5 inches) long.
custom-sized • In the software application, set margins at least
materials
6.4 mm (0.25 inches) away from the edges of
the material.
• Letterhead must be printed with heat-resistant
ink that will not melt, vaporize, or release
hazardous emissions when subjected to the
machine's fusing temperature of 180° C (356° F)
for 0.1 second.
• Letterhead ink must be non-flammable and
Preprinted should not adversely affect printer rollers.
paper • Forms and letterhead should be sealed in a
moisture-proof wrapping to prevent changes
during storage.
• Before you load preprinted paper, such as forms
and letterhead, verify that the ink on the paper is
dry. During the fusing process, wet ink can come
off preprinted paper, reducing print quality.
5.5
<Loading originals and print media>
Guidelines
stable at 180° C (356° F), the machine's
fusing temperature.
exposed backing between them. Labels can
peel off sheets that have spaces between the
labels, causing serious jams.
no more than 13 mm (5 inches) of curl in any
direction.
bubbles, or other indications of separation.