Setting Ethernet Speed; Restoring The Network Configuration; Printing A Network Configuration Page - Xerox Printer fwww User Manual

Enter a byte between 0 and 255 using the number keypad and
5
press the Scroll buttons to move between bytes.
Repeat this to complete the address from the 1st byte to the 4th
byte.
When you have finished, press Enter.
6
Repeat steps 5 and 6 to configure the other TCP/IP parameters:
7
subnet mask and gateway address.
Press the Scroll buttons until Static appears and press Enter.
8
Press the Scroll buttons until Primary DNS appears and press
9
Enter.
10 Enter each byte of the address and press Enter.
11 Press the Scroll buttons until Secondary DNS appears and press
Enter.
12 Enter each byte of the address and press Enter.
13 Press Stop/Clear to return to Standby mode.
Dynamic addressing (BOOTP/DHCP)
To have a TCP/IP address assigned automatically by the server, take the
following steps:
Press Menu until Network appears on the bottom line of the
1
display.
Press Enter when TCP/IP appears.
2
Press the Scroll buttons until DHCP or BOOTP appears and press
3
Enter.
Press Stop/Clear to return to Standby mode.
4

Setting Ethernet speed

You can select the communication speed for Ethernet connections.
Press Menu until Network appears on the bottom line of the
1
display and press Enter.
Press the Scroll buttons until Ethernet Speed appears and press
2
Enter.
Press the Scroll buttons until the speed you want appears and
3
press Enter.
Press Stop/Clear to return to Standby mode.
4

Restoring the network configuration

You can return the network configuration to its default settings.
Press Menu until Network appears on the bottom line of the
1
display and press Enter.
Press the Scroll buttons until Clear Setting appears and press
2
Enter.
Press Enter when Yes appears to restore the network
3
configuration.
Power the machine off and back on.
4

Printing a network configuration page

The Network Configuration page shows how the network interface card
in your machine is configured.
Press Menu until Network appears on the bottom line of the
1
display and press Enter.
Press the Scroll buttons until Network Info appears and press
2
Enter.
Press Enter when Yes appears.
3
The Network Configuration page prints out.
4.2
<Network setup>