Xerox Printer fwww User Manual page 84

Condition
If black vertical streaks appear on the page:
Vertical lines
• The drum inside the toner cartridge has
probably been scratched. Remove the toner
cartridge and install a new one. See page
13.5.
If white vertical streaks appear on the page:
• The surface of the LSU part inside the
machine may be dirty. Clean the LSU. See
page 13.2.
If the amount of background shading becomes
Colour or Black
unacceptable:
background
• Change to a lighter weight paper. See page
5.2.
• Check the machine's environment: very dry
(low humidity) or high humidity (higher than
80% RH) conditions can increase the
amount of background shading.
• Remove the old toner cartridge and install a
new one. See page 13.5.
Toner smear
• Clean the inside of the machine. See page
13.2.
• Check the paper type and quality. See page
5.2.
• Remove the toner cartridge and install a
new one. See page 13.5.
If marks repeatedly appear on the printed side
of the page at even intervals:
• The toner cartridge may be damaged. If a
Vertical repetitive
repetitive mark occurs on the page, print a
defects
cleaning sheet several times to clean the
cartridge; see page 13.4. After the printout,
A a B b C c
if you still have the same problems, remove
A a B b C c
the toner cartridge and install a new one.
A a B b C c
See page 13.5.
• Parts of the machine may have toner on
A a B b C c
them. If the defects occur on the back of the
A a B b C c
page, the problem will likely correct itself
after a few more pages.
• The fusing assembly may be damaged.
Contact a service representative.
Suggested solutions Condition
Background
scatter
A
Misformed
characters
Page skew
Curl or wave
14.11
<Troubleshooting>
Suggested solutions
Background scatter results from bits of toner
randomly distributed on the printed page.
• The paper may be too damp. Try printing
with a different batch of paper. Do not open
packages of paper until necessary so that
the paper does not absorb too much
moisture.
• If background scatter occurs on an
envelope, change the printing layout to
avoid printing over areas that have
overlapping seams on the reverse side.
Printing on seams can cause problems.
• If background scatter covers the entire
surface area of a printed page, adjust the
print resolution through your software
application or the printer properties.
• If characters are improperly formed and
producing hollow images, the paper stock
may be too slick. Try a different paper. See
page 5.2.
• If characters are improperly formed and
producing a wavy effect, the scanner unit
may need service. For service, contact a
service representative.
• Ensure that the paper is loaded properly.
• Check the paper type and quality. See page
5.2.
• Ensure that the paper or other material is
loaded correctly and the guides are not too
tight or too loose against the paper stack.
• Ensure that the paper is loaded properly.
• Check the paper type and quality. Both high
temperature and humidity can cause paper
curl. See page 5.2.
• Turn over the stack of paper in the tray. Also
try rotating the paper 180° in the tray.