Xerox Printer fwww User Manual page 79

Message Meaning
Stop/Clear has been
pressed during an
[Stop Pressed]
operation.
Your machine's
memory has become
Cancel?
full while trying to
Yes
store an original into
memory.
Connection with the
Connection Error
SMTP server failed.
Time expired while
Data Read Fail
reading data.
Check USB Mem.
Storing to the USB
Data Write Fail
memory failed.
Check USB Mem.
There is a problem in
Deve Home
the fuser unit.
Sensor Error
The loaded original
has jammed in the
Document Jam
ADF.
The front cover or
rear cover is not
Door Open
securely latched.
You entered an
Enter Again
unavailable item.
The selected file
File Format
format is not
Not Supported
supported.
There is a problem in
Fuser Fan
the cooling fan of the
Locked
machine.
Suggested solutions
Try again.
To cancel the fax job,
press the Enter
button to accept Yes.
If you want to send
those pages that
have been
successfully stored,
press the Enter
button to accept No.
You should send the
remaining pages
later, when memory is
available.
Check the server
settings and the
network cable.
Try again.
Check the available
USB memory space.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Clear the jam. See
page 14.1.
Close the cover until it
locks into place.
Enter the correct item
again.
Use the correct file
format.
Open and then close
the front cover.
14.6
Message Meaning
You have tried to
select a group
location number
where only a single
location number can
Group Not
be used, such as
Available
when adding
locations for a
Multiple Send
operation.
The colour toner
Install
cartridge is not
[Color] Toner
installed.
The corresponding
Install
part of the machine
[Part]
is not installed.
The colour toner
cartridge you have
Invalid
installed is not for
[Color] Toner
your machine.
The colour part of
Invalid
the machine is not
[Part]
for your machine.
The receiving fax
machine did not
Line Busy
answer or the line is
already engaged.
Low Heat Error There is a problem in
the fuser unit.
Cycle Power
A problem has
LSU Hsync Error occurred in the LSU
(Laser Scanning
Cycle Power
Unit).
A problem has
LSU Motor Error occurred in the LSU
(Laser Scanning
Cycle Power
Unit).
There is a problem in
Main Motor
the main motor.
Locked
<Troubleshooting>
Suggested solutions
Use a speed dial
number or dial a
number manually
using the number
keypad.
Install the colour
toner cartridge.
Install the part into
your machine.
Install the a Xerox-
genuine colour toner
cartridge designed for
your machine.
Install the a Xerox-
genuine part
designed for your
machine.
Try again after a few
minutes.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Open and then close
the front cover.