Eaton PowerXL DA1 Communications Manual page 37

Error no. Device series
dec hex
34 22 DA1
35 23 DA1
40 28 DA1, DC1...E1
41 29 DA1, DC1...E1
42 2A DA1, DC1...E1
43 2B DA1, DC1...E1
44 2C DA1, DC1...E1
49 31 DA1, DC1...E1
50 32 DA1, DC1...E1
51 33 DA1, DC1...E1
52 34 DA1
53 35 DA1
60 3C DA1
61 3D DA1
70 46 DA1
71 47 DA1
72 48 DA1
73 49 DA1
74 4A DA1
2.6.5.2 Actual speed (ID 7)
15 14 13 12
MSB
Message Possible cause
(display on DA1, DC1)
Channel B fault
Enc-05
Error on channels A and B
Enc-06
Motor identification failed
AtF-01
Motor identification failed:
AtF-02
The measured stator resistance is too large.
Motor identification failed:
AtF-03
The measured motor inductance is too low.
Motor identification failed:
AtF-04
The measured motor inductance is too high.
Motor identification failed:
AtF-05
The measured motor parameters do not match.
A phase in the motor cable is not connected or has a discontinuity.
Out-Ph
No valid Modbus frame was received within the time specified
Sc-FO1
No valid CANopen frame was received within the time specified
Sc-FO2
Communications between the device and the plugged-in fieldbus option have dropped
Sc-FO3
out.
Communications between the device and the plugged-in I/O expansion have dropped
Sc-F04
out.
No internal connection to an optional card
OF-01
Optional module in abnormal state
OF-02
Non-supported function block from function block editor
PLC-01
Program from function block editor is too big
PLC-02
Division by zero
PLC-03
Lower limit is higher than upper limit
PLC-04
Overflow table Function block editor
PLC-05
The variable frequency drive's actual speed falls within a value range of
• P1-02 (minimum frequency) to P1-01 (maximum frequency) for DA1
• P-02 (minimum frequency) to P-01(maximum frequency) for DC1
• P-02 (minimum frequency) to P-01(maximum frequency) for DE1
In the application, the values will be scaled by a factor of 0.1.
11 10 9 8
Modbus RTU for variable frequency drive DA1, DC1, DE1 09/16 MN040018EN www.eaton.com
2.6 Operating mode Modbus RTU
7 6 5 4
2 Modbus RTU
3 2 1 0
LSB
33