Backing Up And Restoring The G450 Using A Usb Mass Storage Device - Avaya G450 Manual

Table 19: Software and firmware management CLI commands (continued)
Command
copy usb
startup-config
copy usb SW_image
dir
set boot bank
show boot bank
show download software
status
show image version
Backing up and restoring the G450 using a USB mass storage
device
The G450 USB ports support a USB flash drive and a USB externally powered hub. The ports
also support USB 2.0 high speed (480 Mbits/sec) for faster file transfer between the media
gateway and USB mass storage devices.
Note:
An external USB hub is supported on G450 gateways with hardware
Note:
suffix.vintage C.1 or above.
To check the hardware suffix and vintage, enter show system and check the HW
suffix and HW vintage values.
CLI commands for backing up and restoring files to or from a USB mass storage device enable
you to use a USB port for efficient restoration or replication of a G450 media gateway and for
replacing and upgrading media modules. Using the USB port you can back up or restore
multiple files with one CLI command, which is simpler than the alternative TFTP/FTP/SCP
method, in which files are copied and restored individually.
Description
Upgrade the startup configuration file from the USB mass
storage device
Upgrade the G450 firmware into Bank A or into Bank B, from
the USB mass storage device
List all files in the USB mass storage device connected to the
G450
Set the default bank from which firmware is loaded during
startup
Display the bank from which the G450 is currently set to load
its firmware upon startup or reset
Display the status of the firmware download process
Display the firmware version of the image on both memory
banks of the device
Software and firmware management
Issue 1 January 2008
2 of 2
105