Change Default Settings - Xerox Phaser 3635MFP/S User Manual

11 Setups

Change Default Settings

Set (Power Save) Duration Times
Entry Screen Default
Job Status Default
Feature Default and Priority
182
Changing the user defaults to reflect the needs of the users will make the
machine more user-friendly, increasing effectiveness and productivity.
This utility enables the System Administrator to modify the default 30 minutes
the machine will spend between standby and low power modes.
The machine is designed to be energy efficient and will automatically reduce
its power consumption after periods of inactivity.
• To change the elapsed time for the machine to go from Standby Mode to
Low Power Mode, select the appropriate time frame, e.g. after 5 minutes
duration, after 45 minutes duration, etc.
Select the Save button to confirm the change.
Tools > Device Settings > General > Energy Saver
This feature enables the machine administrator to set which screen the user
sees first.
The Entry Screen appears when the machine resets selections after a user
has completed a job, or after the Clear All button is pressed. The available
options are Features, Job Status, Machine Status and All Services. To set
one of the options, touch the appropriate button and then select Save.
Tools > User Interface > General > Screen Defaults > Entry Screen
Default
Use this feature to set the default screen when the user presses the Job
Status button to the left of the UI. For a full list of available screens, refer to
Job Status Screen in the Copy chapter on page 41.
Tools > User Interface > General > Screen Defaults > Job Status Default
Use this feature to change the priority of the Copy, ID Card Copy, Fax and
Email features.
The highest priority service will be displayed as the default service on the
machine. The next two services will be displayed as buttons in the Features
Xerox Phaser 3635MFP User Guide