Installing The Drivers Manually; Connections - Xerox Phaser 3100MFP/X User Manual

Installing the drivers manually

You can install the printer and scan drivers manually
without running any setup software.
This installation mode is only possible
Note
on Windows 2000, XP and Vista.
1 Locate your USB cable connectors and connect as
shown below on the picture.
2 Power on your machine.
The PC detects the device.
3 Click on L
OCATE AND INSTALL DRIVER SOFTWARE
( ).
RECOMMENDED
The following screen appears:
4 Open the CD-ROM drive, insert the installation CD-
ROM and close the drive.
The drivers are detected automatically.
5 Select X PHASER 3100MFP in the list and
EROX
click on N .
EXT
6 A screen informs you that the drivers have been
installed. Click on the C
You can now use the machine to print and scan your
documents.

Connections

Make sure that your machine is powered off. The
connection between the PC and the machine requires a
USB 2.0 shielded cable no more than 3 meters long.
It is recommended to install the
Xerox Companion Suite software
first and then to connect the USB
cable to your machine (see
Installing the full software
package, page 57).
If you connect the USB cable before
installing the Xerox Companion
Important Suite software the recognition
system (plug and play) identifies
automatically that new hardware has
been added. To start your machine
drivers installation, refer to
paragraph Installing the drivers
manually, page 60 and follow the
instructions on screen. When you
use this procedure, only printing and
scanning functions are activated.
1 Locate your USB cable connectors and connect as
shown below on the picture.
- 60 -
Phaser 3100MFP/X
button.
LOSE