Id Card Copy Mode; Special Setups For Copying; Resolution Setup - Xerox Phaser 3100MFP/X User Manual

Phaser 3100MFP/X
6 Adjust the desired zoom level, from 25% TO 400%
with the buttons
button (only available in 1 Page to 1 copy mode).
7 Adjust the desired origin values with the digital
keyboard buttons
button.
8 Choose the resolution depending on the printing
quality that you want AUTO, TEXT, PHOTO or
QUALITY TEXT with the buttons
confirm with the OK button.
9 Adjust the contrast level with the buttons
then confirm with the OK button.
10 Adjust the desired brightness level with the buttons
or , then confirm with the OK button.
11 Choose the paper type NORMAL, THICK with the
buttons or , then confirm with the OK button.

ID Card Copy mode

The ID CARD copy function is used for copying both sides
of an identity card or driver's license type document on an
A4 format sheet (original document size < A5) or on a
Letter format sheet (original document size < Statement).
The LCD screen displays useful operating instructions
(when the original document should be placed, when the
document should be turned over, etc.) and asks for your
confirmation to proceed with the operation.
This function is available only if the
document to be copied is placed on
the document glass, and if no paper
Important is detected in the automatic
document feeder.
Zoom and Origin adjustments are
not available in this copy mode.
1 Make sure that there is no document in the
automatic document feeder.
2 Press the button.
3 Enter the desired number of copies and confirm
with the OK button.
4 Choose the paper tray AUTOMATIC or MANUAL
with the buttons
button.
Copying in ID Card mode is only
possible on A4 (original document
size < A5) or Letter (original
document size < Statement) paper
Important
size. Make sure that the selected
paper tray uses the correct paper
size.
5 Choose the copying option ID CARD with the
buttons or and confirm with the OK button.
6 Choose the resolution depending on the desired
printing quality AUTO, TEXT, PHOTO or QUALITY
TEXT with the buttons
the OK button. For optimal results with ID
documents, select the PHOTO resolution.
or , confirm with the OK
or then confirm with the OK
or , then
or , then confirm with the OK
or , then confirm with
7 Adjust the contrast level with the buttons
then confirm with the OK button.
8 Adjust the desired brightness level with the buttons
or , then confirm with the OK button.
9 Choose the paper type NORMAL, THICK with the
buttons
The LCD screen displays the following message:
or ,
10 Place your identity card or any other official
document against the document glass, as shown
below:
11 Press the OK button.
The document is scanned then the LCD screen
displays the following message:
12 Turn your document over then confirm with the
OK button.
The machine prints out a copy of your document.

Special setups for copying

Setups done through this menu become the device
default setups after you confirm.
Important

Resolution setup

The RESOLUTION parameter allows you to setup the
photocopy resolution.
841 - ADVANCED FCT/COPY/RESOLUTION
1 Press , enter 841 using the keypad.
2 Choose the resolution with the buttons
- 25 -
or , then confirm with the OK button.
PUT ID CARD
THEN OK
TURN UP DOC
THEN OK
When the quality of the printing is
not satisfying, you can perform a
calibration (see Calibrate your
scanner, page 43).
or ,
or