Error Messages - Xerox Wide Format 510DP Operator's Manual

Error messages

Error Message
CHECK FOLDER
FOLDER COMMUNICATIONS ERROR
#17
F2-01 CHECK FOLDER
FOLDER COMMUNICATOINS ERROR
#01
XEROX WIDE FORMAT 510dp OPERATOR MANUAL
The error messages shown in the table below may appear on the
message display. Follow the instructions in the table before calling
for service.
Table 3. Error Message Table
Problem
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
PROBLEM SOLVING
Solution
1. Press the On-line/Off-line key to
take the printer off-line.
2. Reset the value to NONE.
Refer to "Specifying the finisher
configuration type" in this
manual for instructions.
1. Switch the printer Off.
2. Wait five seconds. Then switch
the printer On.
3. As soon as the Printer
Firmware Version message is
displayed, press the On-
line/Offline key to take the
printer off-line.
4. Reset the value to NONE.
Refer to "Specifying the finisher
configuration type" in this
manual for instructions.
45