Setting The Timers; Adjusting The Print Density - Xerox Wide Format 510DP Operator's Manual

Setting the timers

Adjusting the print density

XEROX WIDE FORMAT 510dp OPERATOR MANUAL
To set the Power Saver mode and Rest mode timers:
1. Access the PRINTER MENU. See "Accessing the Printer
Menu" in this chapter.
2. Press the Previous or Next key until TIMERS is displayed.
3. Press the Enter key to select TIMERS. The current setting for
the READY TO POWER SAVER option is displayed.
4. Do one of the following:
•
To select the READY TO POWER SAVER option, press
the Enter key.
•
To select the POWER SAVER TO REST option:
Navigate to it by pressing the Previous or Next key.
-
- Press the Enter key to select the option.
5. Press the Previous or Next key to scroll through the range of
values.
6. When you scroll to the desired value, press the Enter key to
save your selection.
7. Press the On-line/Off-line key to return to on-line mode.
•
The on-line/off-line indicator will light.
•
The display will indicate " SYNERGIX CS 510dp IDLE "or
"SYNERGIX PS 510dp".
Note: If there is a Scanner connected, the message displayed will
be SYNERGIX CS 510dp. If there is no Scanner connected the
message will be SYNERGIX PS 510dp.
To adjust the print density:
1. Access the PRINTER MENU. See "Accessing the Printer
Menu" in this chapter.
2. Press the Previous or Next key until PRINTER
ADJUSTMENTS is displayed.
3. Press the Enter key to select PRINTER ADJUSTMENTS. The
current setting for the DENSITY option is displayed.
4. Press the Enter key to select DENSITY.
5. Press the Previous or Next key to scroll through the range of
values.
6. When you scroll to the desired value, press the Enter key to
save your selection.
7. Press the On-line/Off-line key to return to on-line mode.
•
The on-line/off-line indicator will light.
•
The display will indicate " SYNERGIX CS 510dp IDLE" or
"SYNERGIX PS 510dp"
OFF-LINE SETUP MENU
23