Operation Steps - Mitsubishi Electric 800 Series Instruction Manual

1.3

Operation steps

: Initial setting
(Hz)
Start command
Start command with
on the operation panel (PU)
How to
How to
give a frequency
give a frequency
command?
command?
Set from the operation
panel
(PU)
(e)
18
1. Introduction
1.3 Operation steps
Frequency command
Inverter
output
frequency
Time
(S)
ON
w
re
m
Change frequency Perform frequency setting
with ON/OFF switches by a voltage output device
connected to terminals (Connection across
(multi-speed setting) terminals 2 and 5)
(External)
(f)
Set from the operation
panel
(PU)
(i)
Step of operation
(a)
Installation/mounting
Wiring of the power
(b)
supply and motor
(c)
Control mode selection
&&Start command via the PU/Ethernet
How
How o connector of the inverter and plug-in
to give a start
to give a start to give a start e option (Communication)
command?
command? m
Initial setting for the Ethernet model and
the safety communication model
Connect a switch, relay, etc.
to the control circuit
terminal block of the inverter
to give a start command. (External)
&&Initial setting for the standard model
Perform frequency setting
by a current output device
(Connection across
terminals 4 and 5)
(External)
(g)
Change of frequency Perform frequency setting
with ON/OFF switches by a voltage output device
connected to terminals (Connection across
(multi-speed setting) terminals 2 and 5)
(External)
(j)
How to
How to w
give a frequency
give a frequency re
command?
command? m
(External)
(h)
Perform frequency setting
by a current output device
(Connection across
terminals 4 and 5)
(External)
(k)
(d)
(External)
(l)