Mitsubishi Electric 800 Series Instruction Manual page 30

 Removal of the lower front cover
• FR-E820-0240(5.5K) or higher
(a)
(a)
Loosen the screws on the lower front cover. (These screws cannot be removed.)
(b) While holding the areas around the installation hooks on the sides of the lower front cover, pull out the cover using its upper side as a
support.
(c) With the lower front cover removed, wiring of the main circuit terminals and control circuit terminals can be performed.
 Reinstallation of the lower front cover
• FR-E820-0240(5.5K) or higher
(a)
(a) Install the lower front cover by inserting the upper hooks into the sockets on the inverter.
(b)
Tighten the screws on the lower part of the lower front cover.
NOTE
• Fully make sure that the lower front cover is reinstalled securely. Always tighten the mounting screws of the lower front cover.
(b)
Loosen Loosen Loosen
(c)
(b)
2.2 Removal and reinstallation of the front cover
Fasten Fasten Fasten
29
2. Installation and Wiring
1
2
3
4
5
6
7
8
9
10