Figure 1-4 Lan Network Manual Setup - Keysight N432A Installation Manual

Static mode (configuring the LAN manually)
In static mode, you must set up the IP address, subnet mask, default gateway,
and DNS servers that are compatible with your network infrastructure. If they are
not set up correctly, the N432A will not be visible on your network.
1
If you configure an invalid IP address or an IP address that is used by another
NOTE
device or host, an error message is generated. This error can be read by pressing
2 Press
3 Press
Figure 1-4
Keysight N432A Installation Guide
Turn on the N432A.
> or sending the SYSTem:ERRor? query.
Error List
>
Remote Interfaces
(see Figure 1-2).
Network Manual
gateway and DNS servers are optional settings.
To individually configure the settings, use the arrow keys, Select key, and
numeric keys to enter the required IP address, subnet mask, default gateway,
and DNS servers.
The values can range between 0.0.0.0 and 255.255.255.255.
LAN network manual setup
to access the Remote Interface display
to set the IP address and subnet mask. The default
Getting Started
45
1