Gpib - Keysight N432A Installation Manual

Thermistor power meter

Hide thumbs Also See for N432A:

Table of Contents

GPIB

1 Install, or ensure that you have installed, the I/O software on your PC.

2 Follow your GPIB interface card vendor's instructions for installing GPIB

3 Connect a GPIB cable between your PC and the N432A.

4 Configure the installed GPIB card based on the vendor's instructions.

5 Use the Connection Expert utility of the IO Libraries Suite to verify that the

If you have installed other I/O software, refer to the documentation that

NOTE

accompanies the software.

6 You can use various programming environments to control the N432A. For

Changing the GPIB address

The GPIB address is an integer between 0 and 30. The N432A is shipped with a

default address of 10. The GPIB address is stored in a non-volatile memory.

GPIB address 21 cannot be used as Keysight GPIB interface card default address

NOTE

is 21. Other GPIB interface card may use a different integer as the default

address.

Keysight N432A Installation Guide

hardware on your PC.

N432A is displayed under the GPIB interface node.

further information, refer to your GPIB card vendor's guide.

Refer to the connectivity guide and the programming guide for an overview on

programming the N432A via GPIB.

Getting Started

Table of Contents