Lenovo System x3850 X6 Installation And Service Manual page 310

Statement 31:
DANGER
Electrical current from power, telephone, and communication cables
is hazardous.
To avoid a shock hazard:
Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical storm.
Connect all power cords to a properly wired and grounded power source.
Connect to properly wired power sources any equipment that will be attached to this product.
When possible, use one hand only to connect or disconnect signal cables.
Never turn on any equipment when there is evidence of fire, water, or structural damage.
Disconnect the attached ac power cords, dc power sources, network connections,
telecommunications systems, and serial cables before you open the device covers,
unless you are instructed otherwise in the installation and configuration procedures.
Connect and disconnect cables as described in the following table when
you install, move, or open covers on this product or attached devices.
To Connect:
1. Turn OFF all power sources and equipment that is to
be attached to this product.
2. Attach signal cables to the product.
3. Attach power cords to the product.
For ac systems, use appliance inlets.
For dc systems, ensure correct polarity of -48 V dc
connections: RTN is + and -48 V dc is -. Earth
ground should use a two-hole lug for safety.
4. Attach signal cables to other devices.
5. Connect power cords to their sources.
6. Turn ON all the power sources.
To remove a 750-watt -48 V to -60 V dc power supply, complete the following steps:
Step 1. Before you begin, read "Safety" on page v and "Installation guidelines" on page 44 .
Step 2. Turn off the server (see "Turning off the server" on page 40) and remove the peripheral devices
cables, excluding the power supply cable. Disconnect all external cables from the server.
Attention: When you handle static-sensitive devices, take precautions to avoid damage from
static electricity. For details about handling these devices, see "Handling static-sensitive devices"
on page 46.
Step 3. Turn off the circuit breaker(s) for the power supplies.
Step 4. If the server is in a rack, at the back of the server, pull back the cable management arm to gain
access to the rear of the server and the power supply.
Step 5. Press and hold the orange release tab to the left. Grasp the power supply handle and pull the
power supply out of the server.
296
System x3850 X6 and x3950 X6 Installation and Service Guide
To Disconnect:
1. Turn OFF all power sources and equipment that is to
be attached to this product.
For ac systems, remove all power cords from the
chassis power receptacles for interrupt power at the
ac power distribution unit.
For dc systems, disconnect dc power sources at the
breaker panel or by turning off the power source.
Then, remove the dc cables.
2. Remove the signal cables from the connectors.
3. Remove all cables from the devices.