Lenovo System x3850 X6 Installation And Service Manual page 276

Removing an ML2 (Ethernet) adapter
Use this information for instructions on how to remove an ML2 (Ethernet) adapter.
To remove an ML2 (Ethernet) adapter, complete the following steps:
Step 1. Before you begin, read "Safety" on page v and "Installation guidelines" on page 44 .
Step 2. Turn off the server (see "Turning off the server" on page 40) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3. Remove the standard I/O book from the server (see "Removing the standard I/O book" on page
224).
Step 4. Open the adapter retention lever.
Step 5. Carefully grasp the adapter and pull it out of the connector on the standard I/O book board.
Step 6. If you are instructed to return the adapter, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Replacing an ML2 (Ethernet) adapter
Use this information for instructions on how to remove an ML2 (Ethernet) adapter.
The following are illustrations of the ML2 (Ethernet) adapters that the server supports. See "Supported ML2
(Ethernet) adapters" on page 88 for more information about the supported Ethernet adapters.
Note: Go to http://datacentersupport.lenovo.com/
Ethernet adapters. Look for the Ethernet adapters under NIC adapters. Use the release notes and read.txt
files for the device driver installation instructions.
The following is an illustration of the Intel I350-T4 ML2 Quad-port 1 Gb-T Ethernet Adapter for System x:
262
System x3850 X6 and x3950 X6 Installation and Service Guide
Fan-pack
and download the latest device drivers for the ML2