Lenovo System x3850 X6 Installation And Service Manual page 355

Table 63. LCD display panel messages (continued)
Message
UEFI: DXE INIT
UEFI: PECI INIT
UEFI: USB INIT
UEFI: PCI INIT
UEFI: VIDEO INIT
UEFI: SMBIOS RDY
UEFI: SMI INS
UEFI: BOOTLEG
UEFI: UNMAP DSA
IMM: UBOOT
Amount of time before
the system timeout if no
Description activity
DXE is running. After 2 minutes
The PECI data is After 2 minutes
ready to be read by
IMM.
The USB bus is After 2 minutes
being initialized.
PCIe initialization is After 10 minutes
running.
Video initialization is After 2 minutes
running.
The SMBIOS tables After 2 minutes
are ready to be sent
to IMM.
UEFI is running. After 2 minutes
Booting legacy. After 2 minutes
UEFI is running. After 2 minutes
IMM is loading After 15 minutes of no
UBOOT. activity or 10 IMM reboot
cycles
Action
1. Restart the server.
2. Flash the UEFI
firmware.
3. Clear CMOS.
1. Restart the server.
2. Flash the UEFI
firmware.
3. Clear CMOS.
1. Inspect the USB
subsystem.
2. Restart the server.
Inspect the PCIe
subsystem.
1. Restart the server.
2. Flash the UEFI
firmware.
3. Clear CMOS.
1. Restart the server.
2. Flash the UEFI
firmware.
3. Clear CMOS.
1. Restart the server.
2. Flash the UEFI
firmware.
3. Clear CMOS.
Make sure that the boot
operating system is
installed correctly.
1. Restart the server.
2. Flash the UEFI
firmware.
3. Clear CMOS.
1. Disconnect the
power from the
server.
2. Reset IMM, see
"Setup utility menu
choices" on page
123.
3. Replace the
standard I/O book.
Appendix A. LCD display panel messages
341