Lenovo System x3850 X6 Installation And Service Manual page 140

– Active Energy Manager
Select this choice to enable or disable power capping. If you enable power capping, the Active
Energy Manager program will limit the maximum power that is consumed by the server.
– Workload Configuration
Select this choice to view and change the settings for expansion cards that require high I/O
bandwidth when microprocessor cores are idle to allow enough frequency for the workload.
– Processors
Select this choice to view or change the processor settings.
– Recovery and RAS
Select this choice to view or set the number of POST attempts and configure start recovery attempts
and backup bank management settings.
– Advanced RAS
Select this choice to enable advanced RAS options.
– Backup Bank Management
Select this option to configure backup bank management settings.
– Disk GPT Recovery
Select this option to view and set Disk GPT (GUID Partition Table) recovery options.
– POST attempts
Select this choice to view or set the number of attempts to POST before the recovery is started.
– System Recovery
Select this choice to view or set the time to start the system recovery attempt.
• POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
• Reboot System on NMI
Select this choice to enable or disable restarting the server whenever a nonmaskable interrupt
(NMI) occurs. The default is Enabled.
• Halt On Server Error
Select this choice to prevent the server from booting the operating system and displaying the
POST event viewer when a severe error is detected during POST.
– Security
Select this option to view or configure the Secure Boot feature and Trusted Platform Module (TPM 1.2).
– Secure Boot Configuration
Select this choice to enable and disable the Secure Boot feature or set the Secure Boot mode.
– Trusted Platform Module (TPM 1.2)
Select this choice to view or configure the TPM setup options.
– Storage
Select this choice to view and manage RAID controller configurations.
• Date and Time
Select this choice to set the date and time in the server, in 24-hour format (hour:minute:second).
This choice is on the full Setup utility menu only.
• Start Options
126
System x3850 X6 and x3950 X6 Installation and Service Guide