Lenovo System x3850 X6 Installation And Service Manual page 102

For information about the supported RAID adapters, see "Supported RAID adapters" on page 86. For
information about the supported Features on Demand software RAID, see "Supported Features on Demand
software" on page 90.
Supported ML2 (Ethernet) adapters
Use this information for an overview of the ML2 (Ethernet) adapters that are supported on the server.
The following table lists the supported Ethernet adapters. For additional information about installing the
adapters, see "Installing an adapter" on page 83 and "Installing an adapter in the standard or half-length I/O
book" on page 90, and "Standard I/O book" on page 31.
Notes:
• You must go to the Lenovo Support web site at
latest device drivers for the ML2 Ethernet adapters. Look for the Ethernet adapters under NIC adapters.
Use the release notes and read.txt files for the device driver installation instructions.
• Each ML2 (Ethernet) adapter comes with a standard profile bracket and a low-profile bracket. One bracket
might already be installed.
Table 24. Supported ML2 (Ethernet) adapters and where you can install the adapters.
Ethernet adapters
Intel X540 ML2 quad-port 1
Gb-T Ethernet Adapter for
System x
Intel I350-T4 ML2 dual-port 10
Gb-T Ethernet Adapter for
System x
88
System x3850 X6 and x3950 X6 Installation and Service Guide
http://datacentersupport.lenovo.com/
Where to install the
adapter
Notes and Features
This adapter can
• Port 1 on the adapter is the default port for IMM Shared
only be installed in
mode when enabled through UEFI.
slot 10 on the
• This adapter provides the following features:
standard I/O book
board.
– Single chip, quad-port 1 Gb Base-T controller with
– PCI Express v2.1 with 5.0 GT/s and 2.5 GT/s support
– Pass-Through (PT) functionality via a sideband interface
– DMTF Network Controller Sideband Interface (NC-SI)
– 1000BASE-T, 100BASE-TX, and 10Base-T link modes
– Flexible port partitioning (32 virtual functions on quad-
This adapter can
• Port 1 on the adapter is the default port for IMM Shared
only be installed in
mode when enabled through UEFI.
slot 10 on the
• This adapter provides the following features:
standard I/O book
board.
– Single chip, dual port 10 Gb Base-T controller with
– 12.5 watts maximum power
– Unified networking delivering LAN, iSCSI, and FCoE
– Two independent 10 Gb Base-T interfaces with SR-IOV
– PCI Express v2.1 with 5.0 GT/s and 2.5 GT/s support
– 10BASE-T, 1000BASE-T, and 100BASE-TX link modes
integrated MAC and PHY
for x1, x2, and x4 links widths
port or 16 virtual functions on dual-port)
integrated MAC and PHY
over 10 Gb Base-T
support
for x1, x2, x4, and x8 links widths
and download the