Press the Down arrow to change the SatSeconds value to 50, 25, 10, or off (the default value is 100).
4.
Press OK to select the value.
5.
Additional Patient Modes
4.6
In addition to setting the patient mode to Adult or Neonate, patient mode settings include Response
mode, Homecare mode, and Sleep Study mode. These are described in the following sections.
Set Response Mode
4.6.1
Response mode establishes the rate at which the monitoring system responds to changes in SpO
readings.
To set Response mode
Access the Change Patient Mode menu.
1.
Press the Up or Down button to highlight the Response Mode menu, then press the OK button to select
2.
the Response Mode menu.
Operator's Manual
Figure 4-8. SatSeconds™ Setting
Additional Patient Modes
2
4-13