Install the PowerGlide Plus Wiring
Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously
on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the
pins and wires.
Install the AutoBoom Node
AutoBoom Node Installed
FIGURE 13.
Mount the AutoBoom node (P/N 063-0130-010) to the AutoBoom valve hydraulic mounting plate (P/N 107-
1.
0171-802) using three 3/8"-16 zinc hex bolts (P/N 311-0054-106) and three 3/8"-16 zinc flanged lock nuts
(P/N 312-1001-164).
Note:
Position the node so that the cable connectors face down.
Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-073) into the corrector
2.
ports of the AutoBoom valve.
Tighten the bolts on the node connectors to secure the connections.
3.
Connect the Harness to the AutoBoom Valve
Locate the Left Press and Right Press connectors on the harness cable (P/N 115-0230-073).
1.
Route the connectors to the AutoBoom valve (P/N 063-0131-124).
2.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
3.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
4.
Manual No. 016-0230-095 Rev. D
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.
PowerGlide Plus
21