Table of Contents
Advertisement
CHAPTER
6
WIRING CONNECTIONS
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on
both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and
wires.
INSTALL THE AUTOBOOM NODE
FIGURE 1. UltraGlide AutoBoom Node Installed
1. Mount the AutoBoom node (P/N 063-0130-053) to the valve mounting bracket (P/N 107-0171-802) using three
3/8"-16 UNC x 1-1/4" zinc plated hex bolts (P/N 311-0054-106) and three 3/8"-16 zinc flanged lock nuts (P/N
312-1001-164).
NOTE:
Position the node so that the cable connectors face down.
2. Insert the large, rectangular node connector on the harness cable (P/N 115-0230-032 or 115-0230-073) into the
both ports of the AutoBoom node.
3. Tighten the bolt on the node connector to secure the connections.
016-0230-129 Rev. B
W IRING INSTALLATION
C H A P T E R 6
CAUTION
Always connect the power cable as the last step
in the wiring process and verify that the power
leads are connected with the correct polarity.
Reversing power leads can cause severe damage
to the equipment.
27
Advertisement
Table of Contents
