Cab Component Installation; Wiring Connections; Install The Autoboom Node - Raven AutoBoom Installation Manual

New holland guardian f/miller nitro n7 series with mono boom

Hide thumbs Also See for AutoBoom:

Table of Contents

CHAPTER

For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on

both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and

wires.

FIGURE 1. AutoBoom Node Mounting Location

1. Mount the AutoBoom node (P/N 063-0130-053) on the existing node mounting bracket located under the

headlight using three 3/8"-16 UNC x 1" hex bolts (P/N 311-0054-105) and three 3/8"-16 zinc flanged lock nuts

(P/N 312-1001-164).

2. Install the large, rectangular node connectors of the AutoBoom harness cable (P/N 115-0230-151) in the correct

ports of the node.

3. Tighten the bolts on the node connectors to secure the connections.

P/N 016-0230-124 Rev. A

C AB COMPONENT

C H A P T E R 5

INSTALLATION

CAUTION

Always connect the power cable as the last step

in the wiring process and verify that the power

leads are connected with the correct polarity.

Reversing power leads can cause severe damage

to the equipment.

Table of Contents