Install The Powerglide Plus Wiring; Install The Autoboom Node - Raven Top Air AutoBoom Installation Manual

Hide thumbs Also See for Top Air AutoBoom:

Table of Contents

INSTALL THE POWERGLIDE PLUS WIRING

Wiring Connections

For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on

both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and

wires.

FIGURE 13. AutoBoom Node Installed

1. Mount the AutoBoom node (P/N 063-0130-010) to the valve mounting plate using three 3/8"-16 zinc hex bolts

(P/N 311-0054-106) and two 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).

NOTE:

Position the node so that the cable connectors face down.

2. Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-045 - Raven, 115-0230-085

or 015-0230-095 - Top Air) into the correct ports of the AutoBoom node.

3. Tighten the bolts on the node connectors to secure the connections.

Manual No. 016-0230-059 Rev G

CAUTION

Always connect the power cable as the last step

in the wiring process and verify that the power

leads are connected with the correct polarity.

Reversing power leads can cause severe damage

to the equipment.

POWERGLIDE PLUS

Table of Contents

Table of Contents